inventiv 739782 Notice De Montage page 32

4. INSERTING AND REMOVING DRILL BIT IN SDS
(NOT SUPPLIED) (SEE FIG. D1, D2)
Take care that the dust protection cap is not
damaged when changing tools.
- Inserting
Clean and lightly oil the bit before inserting. Insert the
dust-free bit into the bit holder with a twisting motion
until it latches.
The bit locks itself. Check the locking by pulling on the
tool.
- Removing
Retract back the bit holder locking sleeve and pull out
the bit.
WARNING! Your new rotary hammer generates
powerful forces to get your job done quickly and
effectively. These forces may cause inferior
quality SDS bits to break and jam in the chuck. We
therefore recommend that only high quality SDS bits
be used with this tool.
OPERATION
1. ON/OFF SWITCH WITH VARIABLE SPEED
CONTROL (SEE FIG. E)
Depress the On/Off switch to start and release it to
stop your tool.
This tool has a variable speed switch that delivers
higher speeds with increased trigger pressure or
delivers lower speeds with reduced trigger pressure -
speed is controlled by varying the pressure applied to
the switch.
2. SWITCH LOCK
The On/Off switch can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the On/Off switch,
place the direction of forward and reverse rotation
control in the center position.
3. FORWARD AND REVERSE ROTATION CONTROL
(SEE FIG. E)
Forward rotation: Push and press the "
back side to body front side for drilling.
Reverse rotation: Push and press the"
front side to body back side for removing the drill bits.
WARNING! Never change the direction of
rotation while the tool is rotating, wait until it has
stopped.
ORIGINAL INSTRUCTIONS
" from body
" from body
32
SAFETY AND OPERATING MANUAL
D1
1
2
D2
1
2
E