Diagnostic Messages - Lumi-O Fantom Guide De L'utilisateur

DIAGNOSTIC
MESSAGE
No message displayed.
Power to the spa has been cut off.
-- --
Overheat. The spas has shut down.
One of the sensors has detected
HH
a 118°F (48°C) temperature at the heater.
Overheat. The spa has shut down.
One of the sensors has detected that
OH
the spa water is 110°F (43°C).
Ice : Potential freeze condition detected.
IC
Spa is shut down. The temperature sensor that is
SA
plugged into the sensor "A" jack is not working.
Spa is shut down. The temperature sensor that is
SB
plugged into the sensor "B" jack is not working.
Temperature sensors are out of balance.
If alternating with spa temperature,
SN
it may just be a temporary condition.
If flashing by itself, spa is shut down.
Significant difference between temperature sensors
HL
has been detected. This could indicate a flow problem
Persistent flow problems.
(Displays on the fifth occurrence of "HL" message
LF
within 24 hours.) Heater is shut down, but other spa
functions continue to run normally.
Possible inadequate water, poor flow or air detected
DR
in the heater. Spa is shut down for 15 minutes.
Inadequate water detected in heater.
(Displays on third occurence of "DR" message.) Spa is
DY
manual power connection instructions. Installation must be performed by a licensed electrician and all grounding connections must be
properly installed.
MESSAGES
MEANING
Temperature unknown
shut down.
WARNING! SHOCK HAZARD!
ACTION REQUIRED
The top side panel will be disabled until power returns.
After the pump has been running for two minutes, the temperature will be
displayed. Spa settings will be preserved until next start up.
Do not enter the water. Remove spa cover and allow water to cool.
Once the heater has cooled, reset by pushing any button. If spa does not
reset, shut off the power to the spa and call your spa dealer
or a qualified service technician.
Do not enter the water. Remove spa cover and allow water to cool.
Once the heater has cooled, reset by pushing any button. If spa does not
reset, shut off the power to the spa and call your spa dealer
or a qualified service technician.
No action required. The pump will automatically activate,
regardless of spa status.
If the problem persists, call your spa dealer or a qualified service technician.
(May appear temporarily in an overheat situation and disappear when the
If the problem persists, call your spa dealer or a qualified servicve technician.
(May appear temporarily in an overheat situation and disappear when the
If the problem persists, call your spa dealer or a qualified service technician.
Check water level in spa. Refill if necessary. If the water level is okay,
ensure the pump has been primed. If the problem persists, call your spa
dealer or a qualified service technician.
Follow action required for "HL" message. Heating capability of the spa will
not reset automatically. Press any button to reset.
Check water level in spa. Refill if necessary. If the water level is okay,
ensure the pump has been primed. Press any button to reset; the spa will
restart after 15 minutes. If the problem persists, call your spa dealer or a
qualified service technician.
Follow action required for "DR" message. Spa will not automatically reset.
Press any button to reset.
28
heater cools.)
heater cools.)