Lumi-O Fantom Guide De L'utilisateur page 21

INSTALLATION AND
4.
that all the jets are in the open position. This will purge air from the water lines and it will make priming the pump easier. Fill your
spa approximately 6 inches (15 cm) from the spa top. The level that you keep your spa water at will be determined by the number
5. When your spa is full of water, plug the power cord into your wall outlet or switch your 220V GFCI breaker to the ON position. The
top side panel display will sequence through a numbered test pattern. When «Pr» is displayed, wait approximately 4-5 minutes for
6. The top side panel will display dashes until the current water temperature is detected and displayed. This may take up to one minute.
7.
or to change this setting, press either the temperature down or up arrow, then press the «Jets» icon. The top side panel display
should show F4.
8.
temperature has been reached. Both components will then shut off automatically. This prevents your water from cooling down. Your
spa is also equipped with freeze protection. If the water temperature drops below 45°F (7°C), the pump will automatically turn on.
It will turn itself off four (4) minutes after the water temperature has risen back to 45°F (7°C).
Your spa automatically checks the water temperature for one (1) minute, every thirty (30) minutes, to increase the temperature if it has
dropped. If you are operating your spa using a 110V electrical supply, the heater will disengage when your pump is turned on to high speed.
If your set temperature has dropped during usage, the heater may not come on automatically when you change your pump from high speed
to low speed. To turn the heater back on, decrease your set temperature to one (1) degree below the current temperature and wait for the
(1) minute.
QUICK START UP GUIDE
IMPORTANT
19
If your source water contains metals
Put