Orbegozo AIR 36 Manuel D'instructions page 11

AIR 36
OPERATIONS
OFF – To turn OFF the appliance.
LOW/MID/HIGH - Press to select the desired fan speed between Low/Medium/High.
COOL- Select the COOL function to start the cooling system. Make sure the water tank is properly filled
with water.
SWING – Select the function SWING, to change the wind direction. The vertical diercction of the air flow
can be adjusted manually by redirecting the outlet up or down.
THE USE OF ICE BOX
Using methods:
a) Add water to the ICE BOX , make sure you don't exceed the MAX. Then put it into the refrigerating
chamber to ensure a frozen effect..
b) Place the ICE BOX into the water tank or upper tank.
c) There are two ICE BOXES, can use circularly.
CLEANING AND MANTENANCE
1. Clean the air filter screen
Unplug the power plug, remove the upper screw of the filter to remove the air filter. Clean the air filter
screen with neutral detergent and banister brush. Then clean it with clear water and reinstall to appliance.
2. Clean the wetted pad
Unplug the power plug, take down the air filter screen (following the same instruction as last point), then
draw the wetted pad from support. Clean the wetted pad with neutral detergent and banister brush. Then
clean it with clear water and reinstall to the appliance.
Attention: the wetted pad must be installed flatly, in order to avoid leaking.
3. Clean the water tank
Unplug the power plug, draw out 1/2 the tank and use soft brush clean it. Use neutral detergent and soft
cloth rub inside of the tank.
Note: if you need to clean the tank completely, you should release the water pump by turning the two clips
that hold it.
4. Clean the shell
Clean with neutral detergent and soft cloth.
Attention: unplug the power plug when clean the appliance. Do not leave any water on the control panel.
11