Perel VTBAL200 Mode D'emploi page 3

4. Operation
4.1 General Operation
Place the scale on a solid, level and non-slippery surface.
Pump the start button once with your foot. Please wait until the display shows 0.0.
The scale automatically switches off after one minute.
4.2 Remarks

The factory default unit is kg. Set the desired weighing unit with the switch in the
back of the scale.

Err appears on the display if the scale is overloaded.

Low battery power. Reload by pumping the start button.

Unit selection (please set unit before weighing).
V. 01 – 19/10/2018
VTBAL200
3 ©Velleman nv