FUXON FS-50 ND Mode D'emploi page 3

Technical data and information
Headlight with 1 LED High Efficiency
u
LED (50 LUX)
Nominal performance: 2,4 Watt
u
Input voltage: 6V AC
u
Tested and approved in accordance
u
with the German Road Traffic Licen-
sing Regulations (StVZO)
With ON-OFF Switch
u
ATTENTION If the diode is not working the complete lighting unit must be exchanged.
Before each ride, make sure that the tail light is not concealed.
Functions:
On/Off
switch
removable
reflector
K 1712
Cableconnector
- +
FS-50
AC 6V
2,4 W
FRONT LIGHT »FS-50 ND«
The headlamp shall only be used under AC
u
voltage
With connecting cable for hub dynamo
u
If the bicycle has a dynamo rear light, this must
u
be connected to the terminals of the headlight.
Mounting:
Mount the headlight with the enclosed bracket on the bicycles
triple clamp in a way that the cone of light reach the road 10 m
ahead of the bike.
The following mounting heights apply to headlamps on bicycles:
min. height: 400mm
max. height: 1200mm
When mounting the light, make sure that the screws are only
fixed so tightly that the position of the light can not be removed
by itself (i.e. torque required for adjustment > 5 Nm).
The adjustment of the headlamp on the bicycle must be such
that others road users are not dazzled its light.
Bicycles must be equiped with at least one forward-facing white
retro-reflector.
direction of travel
GB