Zolux 487044 Guide D'utilisation page 15

1-Dog/2-Dog selector switch
The 1-Dog/2-Dog switch is to the left of the rheostat
intensity dial.
I. 1-Dog - Slide the switch to the left underneath « I », and
press any of the buttons to operate the 1st receiver/collar
II. 2-Dog - Slide the switch to the right underneath « II »
and press any of the buttons to operate the 2nd receiver/
collar.
3/ How to fit the receiver/coller on the dog:
The receiver/collar should be fitted so that the surgical stainless steel contact points press firmly
against the dog's skin. When properly fitted, you should be able to fit a finger or two snugly in
between the contact points and your dog's skin. When properly
fitted, the receiver/collar should not move on the dog. The best
location for the receiver/collar box is either side of the dog's
windpipe. A loose fit can allow the receiver/collar to move
around on the dog's neck. When this happens, the contact
points may rub the skin and cause irritation. If the receiver/
collar is too tight, the dogs may have difficulty breathing.
4/ Finding the right stimulation:
excitement or distraction, you may need to adjust the intensity level upwards.
5/ To maximize the distance:
The training collar has a 400-meter range. Depending on the way you hold your handheld
transmitter, the range may vary. Hold the handheld transmitter away from your body to get the
greatest range. For maximum signal strength, keep your unit properly charged.
6/ Checking the status using the LED indicator:
charge. If you continue to operate the unit when the LED is red (needs charge), it will shut
down.
Stimulation level is controlled by the stimulation intensity dial: (0) being
the lowest level and (100) being the highest level. Setting adjustment
depends on your dog's temperament and threshold for stimulation.
Always start at the lowest level and work your way up.
An appropriate level is when the dog responds to the stimulation with a
mild negative reaction such as jerking/tensing of the neck muscles.
When the dog's attitude changes, especially during times of increased
When the receiver/collar is on and ready to
operate, the LED flashes every 4 seconds. The
LED will glow steadily on both handheld
transmitter and receiver/ collar while any
buttons are pressed.
The LED color indicates battery life level. Green =
full charge, Amber = medium, Red = needs
1-Dog
FR
Switch
EN
2-Dog
Switch
PL
NL
ES
PT
15