Marechal Electric DSN1 Mode D'emploi page 17

►WIRING (1/2)
☼
The contact terminals are spring‐assisted to prevent loosening due to
strand settlement, vibration, or thermal cycling.
• Remove an adequate length of cable outer sheath,
according to the accessory used. The cable sheathing must
extend through the cord grip into the accessory as required to
achieve the intended sealing and cord gripping performance.
• Strip conductors' insulation to the lengths indicated. (Other
conductor sizes can be used with the help of specific amplifier
lugs). A crimped lug may prevent the dispersion of strands of
flexible conductors.
• Do not back terminal screws completely out;
• Fully insert the conductor and tighten the terminal screws to
the torque indicated.
IS 06-2 [DSN] Rev A.1 - 2022-11
17/79 . ,