Remington iLIGHT IPL6500 Mode D'emploi page 16

ENGLISH
INFINITY BULB
C
• The infinity bulb means no replacement parts are needed.
• The bulb in this device is guaranteed to last for the entire guarantee period as
communicated on the guarantee card supplied with this product.
• In the extremely unlikely event that your bulb becomes empty, please contact your
local Remington Service centre who will provide you with a replacement.
, Signs that the bulb needs replacing:
• Bulb Status Indicator is illuminated yellow: 150 Flashes remain in the bulb
• Bulb status indicator is flashing yellow: Bulb is empty.
CLEANING YOUR i-LIGHT DEVICE
C
F CAUTION: Before cleaning your i-LIGHT, make sure that the device is switched OFF and the power cord
is disconnected from the device.
• Regular cleaning helps to ensure optimal results and a long life for the i-LIGHT device.
• To clean the Flash Window, use only the lint-free cloth included with your i-LIGHT device. Take care not
to scratch or chip the Flash Window. Scratches and chips can reduce the effectiveness of the unit.
• For stubborn stains on the flash window, dampen a cotton swab with surgical spirit or rubbing alcohol,
apply to the flash window and clean gently with the lint-free cloth provided.
Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
F WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch the filter
glass or the metallic surface inside the Treatment Head.
F CAUTION: The i-LIGHT is a high voltage device. Never immerse in water. Never clean the unit or any of
its parts under a tap or in a dishwasher.
, Storage
• Switch off the unit, unplug and allow to cool for 10 minutes before storage.
• Store the unit in a dry place at a temperature between 15º C and 35º C
TROUBLESHOOTING
E
• Always read these instructions fully before using i-LIGHT
• Refer to this troubleshooting guide if you experience any problems with i-LIGHT, as this section
addresses the most common problems you could encounter with i-LIGHT. If you have followed the
instructions in this section and continue to experience problems, please contact the Remington®
Service Centre for further assistance.
16