Remington iLIGHT IPL6500 Mode D'emploi page 13

ENGLISH
3 Press the Flash Button to deliver a flash.
• Mild to moderate discomfort is normal. If a flash delivered at Energy Level 1 feels tolerable, increase to
Energy Level 2. Move the device to a different spot and flash the i-LIGHT one more time. Repeat this
process until you find the setting that feels right for you.
• Wait 24 hours and then look at the test area. If the skin appears normal, proceed with your first full
treatment at the energy level you determined is right for you.
, NOTE: You must test the device on each area of the face or body you wish to treat.
TREATMENT
C
, CHANGING ATTACHMENTS
• Your i-LIGHT comes with two separate attachments for the face and body.
• The Body Attachment is specially designed for body hair and can flash every 3 seconds.
• The Facial Attachment is specially tuned for Female Facial Hair and minimises light leakage, it can flash
every 4 seconds.
• The attachments are marked with different icons to identify them (Fig. 8)
, To change attachments:
, WARNING: Always ensure the unit is OFF and the power cord is disconnected before removing the
attachment.
• If the attachment is removed while the unit is powered ON, all indicator lights on the base unit will
flash and audible "beeps" will sound.
• Allow the system to cool down for 5 minutes before attempting to change attachments.
1 Turn the Power Switch OFF and unplug the Power Cord from the electrical outlet.
2 Hold the attachment with one hand while pressing both Attachment Release Buttons with the other
hand and pull gently (Fig. 9).
3 Gently push the other attachment back into the Hand Piece making sure both side tabs click into
place.
, NOTE: the longer tab (with gold circuits) must be on top to properly fit.
Fig. 7
Fig. 8
13