Panasonic ER-SC60 Mode D'emploi page 12

How to use
• Turn the appliance off.
• Apply the oil to the blade before and after each use.
(See page 17.)
• The appliance may not operate in an ambient temperature lower
than approximately 5 °C.
1
Mount the desired attachment and adjust the
trimming height as needed. (See page 13.)
• It can also be used without the attachment.
(Trimming height: approx. 0.5 mm)
2
Press and trim.
• The power cannot be turned on when the
switch lock lamp (
switch is locked.
Press the power switch for more than
2 seconds to unlock. (See this page.)
When the battery capacity is low "LOW"
blinks when operating the appliance.
The appliance beeps twice after switched off.
You can trim approx. 20 minutes after "LOW"
blinks.
(This will differ depending on usage.)
3
Press when finished.
12
ER-SC60_40_EU.indb 12
) blinks, as the power
Locking/unlocking the power switch
► Locking the power switch
1. Press for more than 2 seconds.
• The switch lock lamp ( ) will light up for
5 seconds and turn off.
• The appliance will stop operating.
2. Release .
► Unlocking the power switch
1. Press for more than 2 seconds.
• The switch lock lamp ( ) will turn off.
2. Once the appliance starts operating, release
AC operation
If you connect the AC adaptor to the appliance in the same way as
for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
.
2017/05/25 9:13:19