Bradley S19-310AC Instructions D'installation page 4

Bradley Combination Drench Shower/Eye Wash Unit
Model No. S19-310AC
Installation Instructions continued...
IMPORTANT: Some teflon sealants may cause stress cracks in the plastic
Step 2: Assemble eye wash components
1. After the base is secured, assemble the remaining unit
components as shown in Figures 3 and 4 on pages 5 and 6.
• Apply pipe sealant or tape (supplied by installer) to all
male-threaded pipe joints.
• Use rubber grip pad or strap wrench around pipes when
tightening to prevent marring. Place grip pad on pipe
and then put wrench over grip pad (see Figure 2). With
grip pad in place, turn pipe with wrench.
• The bottom edge of the showerhead should be 7'
(2134 mm) from floor.
2. When connecting steel chain, first connect chain to foot
treadle "S" hook. Then with foot treadle raised up,
straighten chain and connect a link to "S" hook on valve
handle. Make sure steel chain is pulled tight. The length
of chain used will vary.
Step 3: Connect water supply
IMPORTANT: Do not rely on Bradley's Combination Unit to support supply
1. Connect water supply piping to 1-1/4" IPS inlet on unit (piping supplied by installer).
Provide adequate supports (supplied by installer) for supply pipe using pipe hangers or
other means.
2. Connect drain piping to 1-1/4" IPS drain outlet on unit (piping supplied by installer).
3. Mount safety sign to wall or pipe using sign mounting hardware supplied.
4. Open water supply lines. Test for leaks and adequate water flow.
4
showerhead leading to failure. Use teflon tape for sealing the
showerhead.
piping.
Figure 2
Bradley Corporation • 215-163AC Rev. T; EN 01-501
Installation Instructions