Publicité
Les langues disponibles
Les langues disponibles
1800115635 FTJ E0:1800115635 FTJ E0
If there is a problem?
PROBLEM
POSSIBLE CAUSE
Water drips from the
The chosen temperature is too
low and does not allow for the
holes in the soleplate.
formation of steam.
You are using steam while the iron
is not hot enough.
You are using the Shot of Steam
button too often.
There is too much steam.
You have stored the iron horizon-
tally, without emptying it and
without setting it to
Brown streaks come
You are using chemical descaling
through the holes in the
agents.
soleplate and stain the
You are not using the right type of
linen.
water.
Fabric fibres have accumulated in
the holes of the soleplate and are
burning.
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
The soleplate is dirty or
Your are ironing with an inappro-
brown and can stain the
priate program (temperature too
linen.
high).
You are using starch.
There is little or no
The water tank is empty.
steam.
The anti-calc valve is dirty.
Your iron has a build-up of scale.
Your iron has been used dry for too
long.
The soleplate is scrat-
You have placed your iron flat on a
ched or damaged.
metallic rest-plate or ironed over a
zip.
Steam or water come
The steam control is not set to the
from the iron as you
position.
finish filling the tank.
The water tank is overfilled.
The spray does not
The water tank is not filled enough. Fill up th water tank.
spray.
If you have any problem or queries, please contact our
Customer Relations team first for expert help and advice.
845 602 1454 - UK / (01) 677 4003 - ROI
or consult our website - www.tefal.co.uk
2/06/09
13:49
SOLUTION
Position the thermostat in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of the
button.
Reduce the steam.
See the section "Storing your iron".
.
Do not add any descaling agents to the water
in the water tank.
Perform a self-cleaning operation and consult
the chapter "What water should I use?".
Perform the self-cleaning operation and clean
the soleplate with a damp sponge. Vacuum
the holes of the soleplate from time to time.
Make sure that your laundry is rinsed
sufficiently so as to remove any deposits of
soap or chemical products on new clothes.
Clean the soleplate as indicated above. Select
the appropriate program.
Clean the soleplate as indicated above.
Always spray starch onto the reverse side of
the fabric to be ironed.
Fill it.
Clean the anti-calc valve.
Clean the anti-calc valve and carry out a self-
clean.
Carry out a self-clean.
Always set your iron on its heel.
Do not iron over zips.
Check that the steam control is set to the
position.
Never exceeed the Max level.
Page 19
GB
D
F
NL
I
E
P
DK
N
S
FIN
GR
CZ
H
SK
HR
SLO
RO
SR
BG
PL
TR
UA
EST
LV
LT
RUS
19
Publicité
