Kicker ZX1500.1 Manuel D'utilisation page 2

MODEL:
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE
Model:
RMS Power
@ 14.4V, 4Ω mono,  1% THD+N
@ 14.4V, 2Ω mono,  1.5% THD+N
Length
Specifi cations common to all models:
Height
Width
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Selectable Electronic Crossover
Bass Boost
Subsonic Filter
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24" (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
The ZX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown (make sure you set the ZX
2
ZX.1-SERIES AMPLIFIERS Owner's Manual
ZX1000.1 / ZX1500.1 / ZX2500.1
ZX1000.1
500W x 1
1000W x 1
16-3/4" (425mm)
2-1/8" (54mm)
9-5/8" (244mm)
25Hz–200Hz
>95dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Variable lo-pass 50–200Hz, 24dB/octave
Variable 0–18dB @ 40Hz
24dB/octave, fi xed @ 25Hz
ZX AMPLIFIERS
ZX1500.1
750W x 1
1500W x 1
20" (507mm)
ZX2500.1
1250W x 1
2500W x 1
27-1/2 (697mm)