Publicité
110-120V
220-240V
o-
UIll
AC VOLTAGE
PRECAUTIONS
Before
connecting
the AC cord
(LH model
only)
LH model
has an AC VOLTAGE
selector.
Make sure that the AC
VOLTAGE
selector is set to the position matching your local voltage.
If
it is not correctly set, change it with a screwdriver
or a similar tool, Either
11 O-120V or 220-240V
can be selected.
On placement
Do not use the unit in places which are extremely
hot, cold, dusty or
humid. In particular,
do not keep the unit:
. in a high humidity
area such as a bathroom
. near a heater
. in an area exposed
to direct sunlight
(e. g., inside a parked car,
please be careful because it may become extremely
hot)
Place the unit on a flat, even surface.
On safety
When disconnecting
the AC cord, grip the plug and not the cord itself.
Pulling the cord may damage
it and thus be hazardous.
When you are not going to use the unit for a long period of time,
disconnect
the AC cord. If the cord is plugged
in a small amount of
current keeps on flowing to the unit even if the power switch is not on.
If the AC cord is broken or damaged,
or if the wires are exposed,
contact your dealer or an Aiwa service station and have it replaced or
repaired
immediately.
On condensation
When the room is heated,
you sometimes
see water drops on your
windows.
This is called condensation.
This can also occur inside the unit when:
it is moved from a cold spot to a warm spot.
it is used in a room where the heating system has just been turned on.
it is used in a place with a lot of moisture.
it is used where it has direct contact with cool air, such as near an air-
conditioner.
When moisture
has condensed
inside, the unit may not function
nor-
mally.
Let it stand for 1 or 2 hours before turning
the power on, or
gradually
heat the room and dry the unit before use.
Should any trouble occur, disconnect
the AC cord and refer servicing to
qualified
personnel
only.
4
Publicité
