Publicité
Les langues disponibles
Les langues disponibles
InStaLL ranGe Hood (recIrcuLatInG VerSIon)
note
remove protective film entirely.
1. Lift the range hood up under cabinet and
determine final location by centering beneath
cabinet. Mark on the underside of cabinet the
location of the 4 keyhole mounting slots on the
range hood (See slots dimensions on page 9).
Set range hood aside on a covered surface.
A
A. Keyhole slot
Use ¹⁄ ₈ " (3 mm) drill bit and drill 4 pilot holes as
shown.
NOTE: Make the drill holes on the thin area of
the slot.
2. Install the 4 - .45 cm x 1.3 cm mounting screws
in pilot holes. Leave about ¼" (6.4 mm) space
between screw heads and cabinet to slide
range hood into place.
power Supply cable Installation
1. For direct wire installations, run the home
power supply cable according to the National
Electric Code or CSA standards and local
codes and ordinances.
There must be enough wiring from the fused
disconnect (or circuit breaker) box to make the
connection in the hood electrical terminal box.
note
do not reconnect power until the
installation is complete.
2. Remove the screw from the terminal box cover.
Remove terminal box cover and set aside.
A. Terminal box cover B
B. Screw
A
A. Drill pilot hole
A
(6.4 mm)
A
B
3. Remove the power supply knockout from the
top or rear of the vent hood (depending on the
incoming location of your home power supply
cable) and install a UL listed or CSA approved
½" strain relief.
4. Using 2 or more people, lift the hood into final
position. Feed enough electrical wire through
the ½" UL listed or CSA approved strain relief
to make connections in the terminal box.
Tighten the strain relief screws.
5. Position the range hood so that the large end
of the keyhole slots are over the mounting
screws. Then push the hood toward the wall
so that the screws are in the neck of the slots.
Tighten the mounting screws, making sure the
screws are in the narrow neck of slots.
recirculation Vent cover
For installations which are recirculating the air
exhaust, the recirculation vent cover must be
removed.
Remove the recirculating vent cover by removing
the 2 mounting screws with a Phillips screwdriver.
note: For installations which are venting out the
roof or wall, the recirculating vent cover must
remain in place.
Do not remove as unit will not perform properly.
to complete the installation, go to "make
electrical connection" section on page 14.
note: Consider use the A measure for 7"(17.8 cm)
round transition and B measure for recirculating
system.
B.
15
A.
Publicité
