Frigidaire A06823703 Mode D'emploi page 13

Vent connector Installation
note
remove protective film entirely.
Install 7" (17.8 cm) round vent mounting plate.
Attach to range hood using the indicated screws
provided in hardware kit.
note
the 7" (17.8 cm) round vent mounting
plate can be installed up to 1" (2.5 cm)
on either side of the hood center to
accommodate off center ductwork.
power Supply cable Installation
1. For direct wire installations, run the home
power supply cable according to the National
Electric Code or CSA standards and local
codes and ordinances.
There must be enough wiring from the fused
disconnect (or circuit breaker) box to make the
connection in the hood electrical terminal box.
note
do not reconnect power until the
installation is complete.
Before starting the installation, remove
the grease filter, left and right side
panels.
complete installation to reinstall the
side panels.
InStaLL ranGe Hood (ducted VerSIon)
A
A. .29 x .65 cm screws
B
B. 7" (17.8 cm) round vent
mounting plate.
C. Round vent knockout
C
2. Remove the screw from the terminal box cover.
Remove terminal box cover and set aside.
A. Terminal box cover B
B. Screw
3. Remove the power supply knockout from the
top or rear of the vent hood (depending on the
incoming location of your home power supply
cable) and install a UL listed or CSA approved
½" strain relief.
A
A. Power supply
knockout
4. Using 2 or more people, lift the hood into final
position. Feed enough electrical wire through
the ½" UL listed or CSA approved strain relief
to make connections in the terminal box.
Tighten the strain relief screws.
5. Position the range hood so that the large end
of the keyhole slots are over the mounting
screws. Then push the hood toward the wall
so that the screws are in the neck of the slots.
Tighten the mounting screws, making sure the
screws are in the narrow neck of slots.
6. Connect vent duct work to hood.. Seal joints
with vent clamps or duct tape to make secure
and airtight.
7. Check that back draft dampers work properly.
13
A
B