Panasonic CQ-DP975 Manuel D'utilisation page 24

Installation Guide continued
3. a) Plug the Power Connector ©.
b) Install the Trim plate © .
® Trim Plate
4. After installation reconnect the
negative (-) battery terminal.
To Remove the Unit
a) Remove the trim plate with a screwdriver as
shown in the figure.
b) Pull out the unit while pushing two lock levers using screwdriver in the following order.(Fig.1, 2)
c) Remove the unit pulling with both hands.(Fig.3)
Lock Lever
Dismounting Plate
4
2 CQ-DP975/DFX85EUC