1
Prepare the faucet
Préparer le robinet
2
WE RECOMMEND DRILLING A 1-3/8"
DIAMETER HOLE.
NOUS RECOMMANDONS DE PERÇER
UN TROU DE 1 3/8" DE DIAMÈTRE.
Place the spout base (2) and rubber ring (3)
against the faucet body (1). Then screw on
the hot and cold water hoses.
Insert the flexible hoses with faucet body
(1) into the hole (Ø 1-3/8") of the sink or
countertop as shown (Fig.1).
Placez la base du bec (2) et la bague en
caoutchouc (3) contre le bec (1). Ensuite
visser les tuyaux d'eau chaude et froide.
Insérer les tuyaux flexibles avec le corps
du robinet (1) dans le trou ( Ø 1-3/8") du
lavabo ou du comptoir tel qu'illustré (Fig.1).
last revision: 08/02/2016
2
Install the faucet
Installation du robinet
1
3
2
3
Fig.1
Insert the retainer ring (1) to the rod. Secure
the faucet with the metal nut (2). Connect
the hot and cold hoses (3&4) to the water
supply.
Insérer l'anneaux de retenue (1) sur le
manchon fileté. Fixer le robinet avec l'écrou
métallique (2). Connecter les tuyaux d'eau
chaude et froide (3&4) à l'alimentation
d'eau.
4
Apex 91014
robinet de lavabo monotrou
Drain installation
Installation du drain
1
1
4
Fig.2
Unscrew the tube (2) and remove the hex-
agonal nut (3), the white nylon washer (4)
and the black rubber washer (5).
Insert the body of the drain (1) into the hole
of the basin.
Reinsert the washers and the hexagonal
nut in the same order; (5), (4), (3).
Tighten firmly without putting pressure on
the basin.
Screw back the tube (2). It is recommended
to apply teflon tape around the tube's
thread to prevent water leaks.
Dévisser le tube (2) et enlever l'écrou hex-
agonal (3), la rondelle de nylon blanche (4)
et la rondelle de caoutchouc noire (5).
Insérer le corps du drain (1) dans le trou du
lavabo.
Remettre les rondelles et l'écrou dans le
même ordre; (5), (4), (3).
Resserrer fermement sans mettre de pression
sur le lavabo.
Revisser le tube (2). Il est recommandé
d'appliquer du ruban de teflon autour des
fillets afin de prévenir les fuites.
single-hole lavatory faucet
5
4
3
2
Fig.3
aquabrass.com