Technics SE-A1010 Manuel D'utilisation page 8

Operation m
PHONES METER LIGHT
POWER (o; OPERATION
O O
METER LIGHT
Ÿ
PHONES
Headphones {not included)
RQTSOOS | _
Operations
Before operating this unit
1. Set the volume on the control amplifier to the minimum position.
2. Turn on the control amplifier.
Press [POWER].
The operation indicator will illuminate after approximately
4 seconds.
If this unit is connected to an SU-C1010
Once this unit has been turned on, both amplifiers can then
be turned on or to the standby mode using [POWER] on the
control amplifier.
This is possible even when 2 or 3 of these units have been
connected.
Press [A] and/or [B] to select the speaker
system(s) to be used.
The corresponding indicator(s} will illuminate.
Operate the tape deck, CD player, or other
equipment and adjust the volume on the
control amplifier.
After listening Is finished
1. Decrease the volume on the control amplifier.
2. When connected to the SU-C1010
Press [POWER] on the SU-C1010 to switch both amplifiers to
the standby condition.
When connected to a different control amplifier
First switch this unit to the standby position, and then do the
same for control amplifier.
If the unit is turned off while the power meter light is on, a small click
will be heard a few seconds later. This is an automatic adjustment
by the internal mechanism, not an indication of malfunction.
Turning the power meter light on/off al
Press [METER LIGHT].
To listen through headphones B
Decrease the volume on the control amplifier, and connect the
headphones.
Plug type: 6.3 mm (1/4 in.) stereo
if sound from speakers is not wanted, press SPEAKER [A] and/or
[B] to turn off the speaker indicators.
Avoid listening for prolonged periods of time to prevent hearing
damage.