probst UMG-60/150 Instructions D'emploi page 36

Adjustments
5 Adjustments
5.1 Adjustment of the nominal width
Before use, the device must be adjusted to the nominal width (inner diameter) of the gripping goods (steel
pallets).
•
Remove the locking pins and socket bolts in the lower part.
•
Move all three gripping arms of the device according to the size of the gripping goods (bottom sleeves).
•
Position the holes on the lower part in line with the holes in the gripper arm.
•
Insert the socket bolt and secure it with a locking pin.
The nominal width adjustment via the adjustment holes must always be set synchronously for all three
lower parts, otherwise the unit will not hang vertically!
5.1.1 Nominal width adjustment via adjustment holes
Adjustment positions:
Possible ranges of the inner diameters
of the steel pallets in mm:
57200050
1 2 3
~ 600 ~ 700 ~ 800
12 / 18
4 5
~ 900 ~ 1000 ~ 1200
6 7
~ 1500
GB