shark ION RV870 Serie Guide D'utilisation page 4

PREPARING FOR USE
INSTALLING THE SIDE BRUSHES
CHARGING DOCK SET-UP
3 ft.
3 ft.
5 ft.
Place the charging dock on a level surface with its back against a wall, in a space without obstructions, that
can easily be accessed by your robot. Remove any objects that are closer than 3 feet (1 meter) from either
side of the dock, or closer than 5 feet (1.52 meters) from the front of the dock. Plug the Charging Adapter
into a wall outlet. The dock must be plugged in continually for the robot to find it. The LED indicator on the
dock turns green when powered on. The robot will beep when it starts charging on the dock.
s h a r kc l e a n . c o m
Snap the 2 included Side Brushes onto the square
posts on the bottom of the robot.
CHARGING THE SHARK ION™ ROBOT
IMPORTANT: The Shark ION Robot has a pre-installed rechargeable battery. Battery must be fully charged
before using.
To charge, the Power button on the side of the robot
must be in the ON position (I).
If the robot has no charge and cannot return to the
charging dock, place it on the dock manually.
NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are
aligned with the dock. To ensure the robot is docked correctly, refer to the Charge Indicator Lights section.
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If your robot doesn't return to the dock, its charge
may have run out.
The LED on the side of the dock will be green when
the dock is powered. When the robot is placed on
the dock the LED will turn blue.
s h a r kc l e a n . c o m