Publicité
Step 11
å
Fasten the SMALL BACK (L) to the FRAMES (O and P). Turn four 1/2"
HEX HEAD SCREWS (15) a few turns using the L-WRENCH (6). Do not
completely tighten the SCREWS at this time.
å
Fasten the FRAMES (O and P) to the ENDS (B and C). Turn twelve 1/2"
HEX HEAD SCREWS (15) a few turns using the L-WRENCH (6). Do not
completely tighten the SCREWS at this time.
å
Fasten the FRAMES (O and P) to the TOP (A). Turn four 1/2" HEX
HEAD SCREWS (15) a few turns using the L-WRENCH (6).
å
Now, completely tighten all of the SCREWS in this step.
å
Peel the PADS from the PAD CARD (8) and apply them to the bottom
of the FRAMES (O and P) as shown.
A
B
1/2" HEX HEAD SCREW
(20 used in this step)
Page 16
K
K
O
15
6
www.sauder.com/service
C
L
8
P
8
430077
Publicité
