Publicité
Les langues disponibles
Les langues disponibles
electrical information
EN
4.2
wiring diagram (TDI3E)
WARNING
!
•
Do not wire 110 volts to the valve or wall switch.
note:
This appliance comes equipped with a battery back-up. If this back-up is used, install 4 'AA' batteries (not
supplied) into the holder and connect to the wire harness. Connect the battery holder to the wire harness before
using the appliance. Place near the IPI board. If the back-up is used, it must be connected to this 6 volt battery
pack (supplied). Do not connect to a 9 volt battery pack.
26
W415-2883 / A / 07.13.20
Publicité
