Publicité
Les langues disponibles
Les langues disponibles
fi nishing
EN
3.4
media installation
WARNING
!
•
Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
•
Do not change or substitute the glass media material provided with this appliance. If replacing, use only the
replacement glass media available from your local authorized dealer / distributor.
•
Glass media over the burner must not be more than one layer high. More than one layer over the burner will
cause fl ame lifting and sooting problems.
•
Do not place any media (glass or vermiculite) in or around the pilot opening. This will interfere with the pilot
operation.
Evenly spread the glass media onto the media tray, covering the burner tube and tray.
note:
There must only be a single layer of glass media over the burner tube.
Ensure no glass media falls into the pilot opening. If this happens, insert a clean bag into your vacuum cleaner and
vacuum out the glass media. Replacement glass can be purchases from your local authorized dealer / distributor.
Glass media over the burner ports may cause a "puffi ng" sound. To eliminate this sound, simply push the media
away from the burner ports.
note:
The distribution of glass media over the burner ports will infl uence the fl ame height. When the fl ames impinge on
the glass, the glass may discolour slightly and the edges may soften.
note:
Do not use more media than what was supplied with the appliance.
Cleaning Glass Media
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly, and dry before placing over the burner.
3.5
logo placement
Remove the backing of the logo supplied and place, as illustrated.
3.6
glowing embers
WARNING
!
•
Completely blocking the burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed
ignition.
Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should be
taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow.
The ember material will only glow when exposed to direct fl ame; however, care should be taken to not
block off the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER™ logs available from
your local authorized dealer / distributor.
22
W415-2883 / A / 07.13.20
1/2"(12.7mm)
LOGO
1/2"(12.7mm)
Publicité
