Cameo PAR CAN IP65 Manuel D'utilisation page 15

RED
Brightness 00 - 99
COLOUR CHANGE
Press the MODE button repeatedly until "Jxxx" appears in the display. Now the light is in colour change mode. Afterwards,
press ENTER and then use the UP and DOWN buttons to select the colour change function (7 colours) "JU00" or stroboscope
"JF00". To set the colour change rate 00 - 99 and the stroboscope rate (00 = stroboscope deactivated, 99 = maximum strobo-
scope rate), press ENTER again (characters 3 + 4 blink) and then use the UP and DOWN buttons to change the values.
Press ENTER again to confirm.
Note: Both functions can also be used simultaneously.
7 COLOURS
Rate 00 - 99
COLOUR BLENDING
Press the MODE button repeatedly until "Fxxx" appears in the display. Now the light is in colour blend mode. Afterwards, press
ENTER and then use the UP and DOWN buttons to select the function colour blending (7 colours) "FA00" or the stroboscope
effect "FF00". To set the colour blending rate 00 - 99 and the stroboscope rate (00 = stroboscope deactivated, 99 = maximum
stroboscope rate), press ENTER again (characters 3 + 4 blink) and then use the UP and DOWN buttons to change the values.
Press ENTER again to confirm.
Note: Both functions can also be used simultaneously.
7 COLOURS
Rate 00 - 99
AUTO MODE
Press the MODE button repeatedly until "AUTO" appears in the display. In this operating mode, the light switches automatically between colour
change and colour blending mode. The colour change and/or colour blending rate is determined by the settings of the respective mode.
SLAVE MODE
Press the MODE button repeatedly until "SLAV" appears in the display. Connect the slave and master unit with a DMX cable (master unit DMX OUT -
slave unit DMX IN). Now the slave unit follows the master unit.
SELECTING DMX MODE
Press the MODE button repeatedly until one of the four modes appears in the display (2Ch, 3Ch1, 3Ch2, 6Ch). Press ENTER (1st character blinks) and
then use the UP and DOWN buttons to select the desired DMX mode. Confirm with ENTER.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until "A" and 3 additional characters appear in the display. Press ENTER (characters 2, 3 + 4 blink) to use the
UP and DOWN buttons to select the desired DMX start address (A001 - A512). Confirm with ENTER. Note: In order to be able to use the light in DMX
mode, the DMX start address mode must be set.
MANUAL KEYLOCK
This fixture features a manual keylock function to prevent accidental or unauthorized operation. Press the UP and DOWN
buttons simultaneously for approx. 5 seconds until the display reads ‚'- - - -''. Both the menu keys and fixture settings are now
locked. To deactivate the keylock again press the UP and DOWN buttons simultaneously for approx. 5 seconds until the display
shows the previous information.
GREEN
Brightness 00 - 99
STROBE
Rate 00 - 99
STROBE
Rate 00 - 99
BLUE
Brightness 00 - 99
STROBE
Stroboscope speed 00 - 99
15