x-sense XH02-W Manuel De L'utilisateur page 5

01
2. Quickly press the pairing button on the back of one of the 2 units 4 times; it will beep
once and the LED will flash red slowly, indicating it has entered pairing mode and is
waiting for a new unit to be added. Quickly press the pairing button on the other
unit twice; it will beep once and the LED will flash red rapidly, indicating it is
searching for a unit to connect to.
3. After the search is successful and an interconnected group is created, both units will
beep once and automatically exit the interconnection mode. At this point, both units
will only flash once every 60 seconds, indicating they are in normal standby mode.
4. If you want to connect a third alarm to this group, first activate the new device
according to its operating instructions, and then quickly press the pairing button on
either of the 2 previously interconnected units 4 times. This unit will beep once and
the LED will flash red slowly, indicating it is ready to add a new device to the network.
Next, quickly press the pairing button on the new unit twice, and the LED will flash
red rapidly as it searches for a network to connect to. After the third unit successfully
joins the interconnected network, both units will beep once and automatically exit
the interconnection mode.
ON
OFF
06
Press the pairing
button 4 times
Press the pairing
button twice
02
Press the pairing
button 4 times
RF
Press the pairing
button twice
03
07
RF