Publicité
Les langues disponibles
Les langues disponibles
Installation
1. Use the mounting bracket to mark the screw holes on the ceiling or the wall.
2. Drill holes at the 2 marks using an appropriately-sized drill bit. Insert the anchor plugs
and screw the mounting bracket using the screws provided.
3. Attach the alarm to the mounting bracket and turn clockwise to lock the alarm.
4. Test the alarm according to the steps in the section below.
01
NOTE: The test function accurately tests the alarm's heat sensing circuit without the need
to test with fire. If your alarm fails to emit an audible test signal, refer to the
troubleshooting guide at the end of this manual immediately. Never use an open flame to
test this device.
02
03
16
LED Indicator and Audible Alarm
Status
LED Indicator Audible Alarm Action
Standby Mode
The LED flashes
red once every
60 seconds.
Alarm
Unit that
The LED flashes
Mode
detects heat
red 4 times every
and initiates
4 seconds.
an alarm.
All other
The LED flashes
interconnected
red and green 3
units in the
times
network.
sequentially
every 4 seconds.
The LED flashes
red 4 times, then
the LED flashes
green once every
5.8 seconds.
None
3 beeps every 4
The alarm detects
seconds.
heat from high
temperatures, and
this could mean
there's a fire indoors.
3 beeps every 4
Dangerous smoke
seconds.
concentration is
detected by the
initiating unit in the
network. Please
find the initiating
unit and take
action.
4 quick beeps
Dangerous CO
repeating every 5.8
concentration is
seconds.
detected by the
initiating unit, and
has reached the
alarm status.
Please find the
initiating unit and
take action.
17
Publicité
