Volpi KV81 Mode D'emploi page 30

15 Maintenance & Cleaning
Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
isconnect the battery from the tool before checking, maintain and repair the pruning shear,
D
to avoid risk of unexpected actuating of the tool.
Please wear glove before you check the blade sharp or not, that's avoid blade hurt you. Check
the pruning shear frequently, this will keep tool safe and reliable.
•
Don't flush the tools or put it in water, it will cause short circuit or damage the device.
•
Keep ventilation, motor and handle cleaning, always use feather clean the device. Don't use
cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
15.1 Sharpening
•
Sharpening is very important to keep blade in good condition and ensure long life.
•
The tool have attached accessory to sharp blade, always check blade is in good condition before to
start work. Of course, the frequency of sharpening depends on the nature of the sheared wood
(hardness and diameter), pruning rate and sharpening tools (special abrasive tools are provided).
As a result, the blade must be checked frequently during the initial period of use to determine the
appropriate grinding time (check every 15 minutes and you will quickly calculate the frequency).
15.2 Greasing of the blades
The greasing of the blades has sto be repeated each 2-3 working days to guarantee the correct
performance of the tool and to avoid the seize of the blades.
• Open the blades of the pruner.
• Switch off the tool and disconnect the battery.
• Apply the grease between the moving blade and the fix blade (see the picture below).
• Insert the battery on the pruner.
• Turn on the tool and pull the trigger some times to get the grease through the blades.
• Clean the blades from the grease leftover.
30