Publicité
Les langues disponibles
Les langues disponibles
CLEANING AND MAINTENANCE
CLEANING THE MACHINE
Clean the machine with a slightly moist soft cloth. Dry the machine off well. Never submerge the machine
in water!
CLEANING THE DUST RESERVOIR
1.
Never exceed the maximum indicator on the dust container. Press the button to open the dirt
receptacle to empty it. The dust container falls open and you can then remove the coarse dirt.
2.
Press the release button to remove the dirt receptacle. The dirt
receptacle will come loose from the motor section. You can now clean
all the parts separately. We recommend you do this with compressed
air. If you do not have compressed air, you can wash out the filters.
Make sure they are completely dry before using them again.
A. HEPA filter: this round dust filter captures the small dust particles.
B. Plastic coarse debris filter: this ensures that the large dust particles
remain in the dirt receptacle.
C. Dirt receptacle: this is where all large dirt particles are collected.
3.
Pull the filters out of the dirt receptacle. Remove the HEPA filter
(A) from the coarse debris filter (B) by pulling it up. You can also
disassemble the coarse debris filter (B) for more precise cleaning. Pay
attention to the lock symbol on the filter. Blow the filters clean with
compressed air. You can also clean the filters and the dirt receptacle
(C) under running water. Make sure they are completely dry before
using the appliance again.
4.
Replace the HEPA filter in the coarse debris filter.
5.
Put the filters back in the dirt receptacle. Make sure that the notch in the dirt
receptacle lines up with the protrusion in the filter.
6.
Put the dirt receptacle back on the motor section. You will hear a click when it
is in place.
We advise replacing the filters regularly to ensure an optimal operation of the machine. Dirty filters
will reduce the suction power drastically. After every cleaning, clean the dust reservoir and the filters to
extend the life span of your machine.
CLEANING THE FLOOR BRUSH
1.
Remove the floor nozzle from the upright vacuum cleaner. Press the
the floor nozzle and remove it from the machine.
2.
Slide the cover on the right side of the floor brush to the right.
3.
Remove the
rotating floor brush from the floor nozzle.
4.
Remove hairs and other dirt that have wrapped around the floor brush. If you do not clean the floor
brush regularly, it will become damaged and your machine will become unusable.
www.domo-elektro.be
A
B
C
release button at the back of
DO2035SV
29
Publicité
