switel CA 2000 Manuel De L'utilisateur page 6

AT A GLANCE
1
2
3
1 IR LED – Infrared LEDs provide viewing in no/low light conditions
2 Lens – Catches the video in front of the lens and transmits video from camera
to receiver
3 PIR sensor – Detects motion in front of the lens and emits detection signal to
transmitter
4 Microphone – Captures the sound on camera side and transmits the sound
from camera to monitor
5 Speaker – Produces the sound transmitted from the monitor
6 Camera Antenna – Receives & Sends signals to or from the Receiver
7 Bracket – Use the bracket to mount the camera on a wall or other flat surfaces
8 Power Jack – Connect the DC 9V Power Adaptor to the Camera
9 Pairing Button – The pairing button is located on the back of the camera
behind by the stand mount
Note: This camera includes an Auto Mechanical IR Cut Filter. When the camera
changes between day mode and night vision mode, an audible clicking noise may be
heard coming from the camera. This clicking is normal, and indicates that the
camera filter is working.
SET UP THE HARDWARE
General
The camera included with your monitor is weatherproof and have an IP54 rating.
Water can be sprayed on them and they will still work; however, the cameras cannot
be submerged. Although the cameras can be exposed directly to the rain, it is
recommended that, if they are used outdoors, they be mounted under some type of
cover like a patio overhang or eave. As rainwater drops start to dry on the camera
glass, it can create spots that will reflect the light from the infrared LEDs used for
night vision, thus causing lower quality video. Also, as dust, grime, and cobwebs
accumulate on the camera glass, they can reflect light from the infrared LED and
might lower video quality. Periodically clean the lens glass with a soft cloth.
4
6
4/5 7
8
9