AGA MARVEL PROFESSIONAL MP15BCG4 Serie Instructions D'installation, D'utilisation Et D'entretien page 13

WARNING
!
Use extreme caution with the articulated hinges. The
hinge is self closing and many pinch points exist prior
to built-in installation. Do not remove the cabinet "Z"
bracket from the top of the cabinet.
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 13. Set the gasket
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack along with the door lock,
which is provided on certain models.
Cabinet
"Z" Bracket
Figure 11
"P" clamp
and screw
Figure 11b
Bottom of
door
OVERLAY DOOR PANEL INSTALLATION
Loosen (do not remove ) these
2 phillips head screws on the
top and bottom hinges
Figure 11a
Wire connector
see Figure 12
Figure 12
Holes in
gasket
retainer.
Figure 13a
Figure 13
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 14 to 21. The window cut out
is for glass door models only. If your appliance has a lock
also drill the lock hole in the panel, see Figure 22.
13
Press and hold this down
this tab on the wire connec-
tor and pull the connector
apart.
Overlay panel
flush with top
and side of
Overlay panel to
be centered on
width of door.
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.
door.