Beamz DMX-004DII Manuel D'instructions page 7

Function and Control panel
Operation
The unit has two operation modes, DMX or Auto mode.
Auto mode
The unit has 16 inner programmes. You can set the speed of the programmes.
1. Connect lights.
2. Press "MODE", select P (programm)
3. Press "UP" or "DOWN", select programm P1 – P16
4. Press "MENU", select Sp (speed)
5. Press "UP" or "DOWN", select speed SP01 – SP99, 01 for the 30sec step and 99 for the fastest 10 steps per
second.
DMX mode
The unit can set to 1 channel, 2 channel or 4 channel DMX.
1. Connect the unit to a DMX controller
2. Press "MODE", select A (adress)
3. Press "UP' or "DOWN" to select the DMX start-adress 001-512
4. Press "MENU", select CH (channel)
5. Press "UP" or "DOWN", to select 1, 2 or 4 CH DMX
CH1 means all the units outputs receive the selected DMX value.
CH2 means unit is in 2 channel mode. CH1 and CH2 are one DMX channel. CH3 and CH4 are second DMX
channel.
CH4 means unit is in 4 channel mode. All 4 outputs have there own DMX channel
6. DMX value of switching. 0 to 127 is Off, 128 to 255 is On.
www.beamzlighting.com
1. Output sockets
2. Green LED: Indicate the output of related channel
3. Display: Display all kinds of operating modes.
4. Up button: Select UP.
5. Down button: Select DOWN
6. Menu button: In automatic or DMX mode, select different
functions
7. Mode button: Choose to work in automatic or DMX
mode
Output fuse: Fuse for each channel (6.3A).
8.
Always replace with same type of fuse and always disconnect unit from
main power before replacing the fuse.
9. Power switch
10. Power Wire
11. DMX output
12. DMX input