Publicité
Les langues disponibles
Les langues disponibles
Installing the holders and
the steering remote control
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Hook the belt on to the holder.
(Fig. 15)
2. Fix the holder to the inside edge
of the steering wheel so that the
holder is facing the driver.
(Fig. 16)
• Wrap the belt around the outside edge of the
steering wheel, passing the end through the
slot in the holder.
• Pull on the belt to tighten it then secure it
using the other two hooks on the holder.
3. Cut off the extra portion of the
belt. (Fig. 17)
• If some of the belt still protrudes, fold it
back into the slot so that it does not interfere
with driving.
4. Fasten the other belt in the same
way.
Fig. 15
5. Install the remote control unit in
the holder. (Fig. 18)
• When removing the remote control unit
from the holder, move the corrugated
release section (*1) toward the steering
wheel as far as possible before sliding the
remote control unit toward you.
Fig. 16
Fig. 17
*1
Fig. 18
12
Publicité
