GardePro A3S Manuel D'instructions page 21

9.2. SENSING ANGLE AND DISTANCE TEST
To test whether the camera can effectively monitor the area you
choose, this test is recommended to check the sensing angle and
monitoring distance of the camera. To perform the test:
Switch the camera to the SET mode.

Select "Motion Test" in the Menu. The camera will

countdown a max 60-second delay and will be ready to
capture motions. (Note: The delay time may be less than 60
seconds, depending on the actual time of the motion sensor
to be activated. The delay time is 60 seconds minus the
power-on time.)
Close the camera door.

Make movements in front of the camera at several positions

within the area where you expect the game or subjects to be.
Try different distances and angles from the camera.
If the motion indicator LED light (RED light) blinks, it

indicates that position can be sensed. If it does not blink, that
position is outside of the sensing area. (Note: The red light
will blink only when the motion is within the sensing area of
the central PIR sensor. The central sensor's sensing angle of
view is 60°. Each of the side sensors has a 30° angle of view,
which is only used to pre-activate the camera and accelerate
Figure 8: Mounting the Camera
17