Publicité
Les langues disponibles
Les langues disponibles
A 3-way power switch is used to select the main operating
modes: OFF, ON, and SET (Figure 5).
A control key interface with six keys is primarily used in SET
mode to select operational functions and parameters. As shown
in Figure.5, the keys can also perform a second function
(shortcut operations in SET mode) in addition to their main
function.
5. INSTALLING THE BATTERIES AND SD CARD
Before you start learning how to use your camera, you will first
need to install a set of batteries and insert an SD card. Although
that may only take you a minute, there are some important notes
about both batteries and SD cards you should be aware of, so
please take the time to read the following directions and
cautions:
5.1. LOADING BATTERIES
After opening the cover of the battery compartment, you will
see that the camera has eight battery slots (Figure 6). A full
eight batteries must be installed for the camera to operate. Be
sure to insert each battery with correct polarity (negative or
"flat" end against the long spring of each battery slot).
In the SET mode when battery power level gets low, the
message "Low Battery" will show on the screen, please replace
the batteries. If the battery indicator shows in RED, this does
mean the batteries are not able to drive IR LEDs flash at night,
however the batteries still work at daytime until "Low Battery".
If you want to continue night vision, please replace the
batteries.
6
Publicité
