Publicité
Les langues disponibles
Les langues disponibles
Charging the battery:
1.
Connect charger to a USB port and the LED will
blink red slowly. Connect to battery.
2.
When charging the LED status will be solid red.
Once charged the LED light will turn off.
3.
NEVER leave the battery unattended whilst
charging.
4.
If the battery or charger become hot during the
charging process, disconnect both the battery
and charger immediately as this may have been
caused due to an internal short-circuit.
Notes on Battery use:
•
Always allow the battery cool after use, before recharging.
•
Always inspect the battery before charging.
•
Any bare wires, split heat shrink or leakage is a sure sign of abuse.
•
Never attempt to charge dead or damaged batteries.
•
Do not disassemble the battery or cut the connector wires.
•
If the battery connector gets hot enough to melt there is most likely a serious problem with your model, driveline, battery wires or speed controller.
Find and correct the problem before installing another charged battery pack.
•
NEVER charge the battery unattended in case of overcharging, you need to be able to monitor the battery during charging
•
Charge away from flammable objects and on a non-flammable surface in case the battery becomes too hot.
SPEED CONTROL/RECEIVER UNIT
The LED sequence for the USB charger is:
Red light on = charging
7
Power Off:
After use, to power off the
model and transmitter please
follow the steps below:
1.
Toggle the model's
power switch to its 'OFF'
position. Disconnect the
model's battery from the
model's receiver.
2.
Toggle the transmitter's
power switch to the
'OFF' position.
Note: Always power off the
model and disconnect its
battery BEFORE turning off
the transmitter. Failure to do
so may lead to damage or
serious injury.
Light off = charged
Publicité
