Keurig Hot K-Cup K150 Serie Manuel D'utilisation page 6

P6 20162461 T5274_K150_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
SECTION 1
Setup & First Brew
You cannot use your Keurig
IMPorTanT:
until it has been set up for its first use.
If the brewer has been exposed to
noTe:
temperatures below freezing, allow the brewer at
least two hours to reach room temperature before
brewing. A frozen or extremely cold brewer will
not operate.
Setting up Your Brewer
1
fig.
Remove all pieces of packing tape from
1.
the brewer and Drip Tray. Remove the
clear plastic film from the LCD Screen.
Welcome To The
Keurig 150 Brewing
® Unwrap the Power Cord and plug the brewer
System Designed
into a grounded outlet.
For The K-Cup Pod
®
Turn the brewer on, the Power Switch is
2.
located at the top left hand side of the brewer
on the back. The brewer's LCD Screen will
Español Français
display the power up welcome screen (fig. 1).
Remove the Water Reservoir from the brewer
3.
by first removing the Water Reservoir Lid,
then lifting the Water Reservoir straight up
and away from the brewer (may be tight).
Rinse with fresh water.
brewer
®
Please Wait
6
Fill the Water Reservoir to and
4.
2
fig.
not beyond the MAX FILL line
with bottled or filtered water.
Replace the Water Reservoir on
the brewer making sure that the
locking tabs engage with the
brewer (fig. 2). Replace the
Water Reservoir Lid on the
Water Reservoir.
The brewer will automatically fill
5.
the internal water tank with
water and then the water will be
heated. This will take about
3 minutes. During the heating
3
fig.
period, "HEATING PLEASE
WAIT" will be displayed on the
LCD Screen (fig. 3).
Place a 10 oz. mug on the Drip
6.
Tray Plate, then lift and lower
Heating...
the Handle. The BREW Button
will now be illuminated. Press
the BREW Button to start
a cleansing brew.
K-Cup
for this sequence.
NOTE: A
pod should not be used
®