Keurig Hot K-Cup K150 Serie Manuel D'utilisation page 18

P18 20162461 T5274_K150_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
SECTION 4
Troubleshooting
SITUATION SOLUTION
Brewer does not • Plug the brewer into an independent outlet.
• Check to be sure that it is plugged in securely.
have power
• M ake sure that the brewer is powered on and
LCD Screen is illuminated.
• Reset circuit breaker if necessary.
• Plug into a different outlet.
• A fter placing the K-Cup
Brewer will
make sure the Handle is pushed down securely and the
not brew
LCD Screen reads "READY TO BREW" with the BREW
Button flashing, then press the BREW Button.
• T he Exit Needle may be clogged (refer to page 15).
LCD Messages
• I f the Water Reservoir is empty and needs to be refilled,
the LCD Screen will direct you to "LIFT WATER
RESERVOIR, FILL WATER RESERVOIR, REPLACE
WATER RESERVOIR" with slideshow of images. Follow
these instructions.
• If the water flow has been interrupted, the LCD Screen
will state "WATER FLOW INTERRUPTED. TO RESET,
PLEASE LIFT AND REMOVE WATER RESERVOIR."
When Reservoir has been removed, screen states
"IF NECESSARY, PLEASE FILL WATER RESERVOIR
TO MAX FILL LINE. THEN REPLACE."
Follow these instructions.
• I f the brewer has been plumbed using a Direct Plumb Kit
and if the water flow has been interrupted, LCD Screen
will state "WATER FLOW INTERRUPTED. TO RESET,
PLEASE PRESS BREW BUTTON."
Follow these instructions.
• I f the messages persist after following these
instructions, contact your Keurig Authorized Distributor.
Brewing a partial cup
pod in the K-Cup Pod Holder,
® ®
18
SITUATION SOLUTION
Chlorine or mineral Consider using bottled water, filtered water or the
•
taste in coffee Omnipure KQ8A Water Filter (#5572)
(available from your KAD).
The Exit Needle may be clogged (refer to page 15).
•
Clean the K-Cup
•
and rinse under faucet (refer to pages 14-15).
The Water Reservoir may have been removed
•
during brewing. Replace the Water Reservoir
and perform a water brew without a K-Cup
Descale the brewer (refer to pages 15-16).
•
If you have repeated the descale procedure on your
•
brewer two times and it is still only brewing
a partial cup, contact your Keurig Authorized
Distributor.
The time is not The time will not be displayed on the LCD Screen
•
displayed on the unless you have set it. To set the clock, follow the
LCD Screen procedure on page 11.
If power is interrupted to the brewer, you will
•
need to set the clock again using the procedure
on page 11.
Brewer shuts Check to make sure that the Auto Off time
•
off or turns on and/or On/Off time features have not been set.
automatically
To do this, enter the Menu Mode (refer to page 9)
and follow instructions to reset (refer to page 12).
If any problems persist, contact your Keurig Authorized Distributor.
Pod Holder Assembly if necessary
®
pod.
®