Keurig Hot K-Cup K150 Serie Manuel D'utilisation page 16

P16 20162461 T5274_K150_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
SECTION 3 Cleaning & Maintenance
Descaling Procedure
Empty the water from the Water Reservoir. If there is a Keurig
Filter, remove and set aside. Disable Auto Off features for your brewer
(refer to page 12).
STEP 1: FIRST DESCALING SOLUTION RINSE
• Press the Power Switch to power the brewer off.
• Pour the entire bottle of Keurig Descaling Solution into the Water
™
Reservoir. Then fill the empty bottle with bottled or filtered water and pour
into the Water Reservoir. Press the Power Switch to turn the brewer
back on.
• P lace a large mug on the Drip Tray Plate and run a cleansing brew using
the largest brew size. Do not add a K-Cup
mug into the sink.
STEP 2: SECOND DESCALING SOLUTION RINSE
• Repeat the brew process without a K-Cup
indicated. Let the brewer stand for at least 30 minutes while still on.
• After 30 minutes, discard any residual solution, and rinse the Water Reser-
voir thoroughly.
STEP 3: FRESH WATER RINSE
• Ensure the Water Reservoir is filled with fresh water.
• Place a large mug on the Drip Tray Plate and run a cleansing brew using
the largest brew size. Do not add a K-Cup
mug into the sink.
• Repeat brew process until you have completed at least 12 brews using the
NOTE: The cleaning action of Keurig
Water
™
foam dispensed from the brewer. This is natural, as the solution is reacting
with the scale inside. For a brewer that is heavily scaled, the brewer may not
fill properly after the descaler is added. If this occurs, you may see only a small or
no output dispensed followed by the sound of air blowing out. If this occurs:
• Turn off and unplug the brewer.
• If there is Keurig
• Plug the brewer back in, power on, and repeat the Step 3 Fresh Water Rinse
pod. Pour the contents of the
®
For further descale information please contact your Keurig Authorized Distributor.
Service
pod, until "ADD WATER" is
®
Beyond these recommended cleaning and maintenance procedures this
brewer is not user serviceable. For service, please refer to the Warranty
section of this guide.
Purging the Brewer
pod. Pour the contents of the If your brewer has not been used for more than one week, you should purge
®
the water from the internal water tank.
16
largest brew size. You may need to refill the Water Reservoir at least one
time during this process.
Descaling Solution may result in a
™
Descaling Solution in the Water Reservoir, discard the
™
contents, rinse the Water Reservoir thoroughly and refill with water.
cycle. The brewer should begin to function normally as the solution is rinsed
out and the scale is removed. If problem persists, allow the brewer to sit
unplugged for at least 30 minutes before continuing with the rinse.
If there is water in the Water Reservoir, remove the Water Reservoir Lid,
1.
then lift the Water Reservoir straight up and away from the brewer.