Publicité
Les langues disponibles
Les langues disponibles
TO LEVEL MOWER
HOUSING
Adjust
the mower
while
riding
mower
is
parked
on level ground or driveway.
Make
sure
tires are properly
inflated
(See side
of tire for proper PSi).
If tires are over or
underinflated,
you will not properly
adjust
your mower°
SIDE-TO-SIDE
ADJUSTMENT
• Raise mower to its highest position.
,
Measure
distance
"A" from bottom
edge
of mower to ground
level at front corners
of mower.
• To raisethe
rightside
ofthe mower, tighten
lift link adjustment
nut.
• To Iowerthe
right side ofthe mower, loosen
lift link adjustment
nut.
NOTE:
Each full turn of adjustment
nut will
change
mower height about 3/16'L
Bottom Edge of
Bottom Edge of
Mower to Ground
Mower to Ground
q l, l t!ii . ...................................
ii . ......
!Ilt i ;
, Recheck
measurements
after adjusting°
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck must be level side-to
side,
To obtain the best cutting results, the mower
housing should be adjusted so thatthe front is
approximately
1/8" to 1/2" lower than the rear
when the mower is in its highest position.
Check
adjustment
on right
side
of riding
mower. Measure distance"F"
directly in front
and behind the mandrel
at bottom
edge of
mower housing
as shown,
Trunnion
TO REPLACE
MOWER
BLADE
DRIVE
BELT
MOWER
DRIVE
BELT REMOVAL
1_ Park riding mower on a level surface..
2. Set parking
brake.
3.
Lower mower to its lowest
position.
4.
Remove
mandrel
cover
from
mower
deck.
5.
Remove
rear engine plate from uniL
6.
Remove
rear belt keeper
from unit.
74 Carefully
roll belt over
the top
of the
mower blade mandrel.
8.
Remove
belt from idler pulleys.
Mower Drive Belt
\
Keeper
, To lower front of mower housing
turn nuts
"G" and "H" clockwise.
• When
distance
"F" is 1/8" to 1/2" lower
at front than rear, tighten
nut "H" against
trunnion
on front link.
• To raise front of mower housing
turn nuts
"G" and "H" counter
clockwise.
• When
distance
"F" is 1/8" to 1/2" lower
at front than rear, tighten nut "H" against
trunnion
on front link.
NOTE:
Each full turn of "G" will change
"F"
by approximately
about 3/8".
• Recheck
side-to-side
adjustment.
Idler Pulleys
9. Check idler pulleysto
seethatthey
rotate
freely.
! 0. Remove
belt from rear drive pulley.
MOWER
DRIVE
BELT INSTALLATION
Install
in reverse
order
following
instruc-
tions in "MOWER
DRIVE BELT REMOVAL"
section.
21
Publicité
