Publicité
Les langues disponibles
Les langues disponibles
Replacing carbon brushes:
(For parts name, refer to Fig. 1)
Loosen the set screw then remove the cap cover. Remove the brush cap and carbon
brush. After replacing the carbon brush, do not forget to tighten the brush cap securely
and to install the cap cover.
5. How to replace grease
This machine is full air-tight construction to protect against dust and to prevent lubricant
leakage. Therefore, the machine can be used without lubrication for long periods.
Replace the grease as described below.
Grease replacement period
After purchase, replace grease after every 6 months of usage. Ask for grease replacement at
the nearest metabo HPT Authorized Service Center. Proceed for replacement of grease.
Grease replenishment
CAUTION:
Before replenishing the grease, turn the power off and pull out the power plug.
(1) Remove the crank cover and wipe off the
grease inside. (Fig. 5)
(2) Apply 1.1 oz (30 g) of metabo HPT Electric
Hammer Grease A (optional accessory,
contained in tube) to the crank case.
(3) After replenishing the grease, install the crank
cover securely
NOTE: The metabo HPT Electric Hammer Grease
A is of the lower viscosity type. When the
supplied
grease
purchase from a metabo HPT Authorized
Service Center.
6. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a metabo HPT AUTHORIZED
SERVICE CENTER, ONLY.
7. Service parts list
A:
Item No.
B:
Code No.
C:
No. Used
D:
Remarks
tube
is
consumed,
English
Crank cover
Fig. 5
11
Publicité
