Thermostat Settings; Air Handler Settings - EcoNet UETST700SYS Guide D'utilisation

Thermostat Settings

Installer Settings
80 80 68
Resume Schedule Away
75 75 71
Furnace AC/HP Thermostat
Air Handler Defaults
Home Away
Warning! These settings are to be used
by a qualified HVAC contractor ONLY
72 65
OFF
BACK
Thermostat Settings
68 80 80
Thermostat Brand Ruud
Resume Schedule Away
71 75 75
Aux Heat Hold Off Time Auto
Filter Check Hour 9 am
Anticipator 0
Home Away
65 72
OFF
BACK
The higher the negative The higher the positive
number the faster the system number the longer the system
will cycle off, increasing the will stay cycled on, lowering
number of times the system the number of times the
cycles off in an hour. system cycles off in an hour.
0
-5 -4 -3 -2 -1 1 2
Factory set default
and
recommended
rate of equipment
cycling.

Air Handler Settings

Installer Settings
80 68 80
Resume Schedule Away
75 71 75
Furnace AC/HP Thermostat
Air Handler Defaults
Away Home
Warning! These settings are to be used
by a qualified HVAC contractor ONLY
65 72
OFF
BACK
Air Hander Settings
68 80 80
Electric Heater Size None
Resume Schedule Away
71 75 75
EXV Superheat Offset 0° F
O Input Fan Control Off
Home Away
Aux #1 Config N.O. Off
Aux #2 Config N.O. Off
Filter Type Media
65 72
OFF
BACK
> Return to Table of Contents
Thermostat Status (Menu > Settings > Installer > Thermostat)
Zone 3
Go to Menu > Settings > Installer (tap and hold) > Thermostat.
44% 44% 47%
Dining Room
Thermostat Brand – The EcoNet Smart Thermostat will automatically populate
Zone 3
when the system starts up by reading the equipment's model data card.
Aux. Heat Hold Off Time – This setting is designed to keep the auxiliary heat
44% 44% 47%
off for a duration of time determined by the user. The time periods are:
• Auto: The thermostat will energize Aux Heat once the temperature has
Dining Room
reached 1 full degree beyond the heat set point. Also if the heating
system is not maintaining the set point using the heat pump alone.
• 1-60 min: The number of minutes the system will keep the Aux Heat
from coming on even when the space temperature goes beyond 1 degree.
Filter Check Hour – The time of day when the EcoNet Smart Thermostat will
check the air filter status.
Anticipator – Gives the user the ability to accurately control the system
from overshooting in the Heating and the lag of delivering conditioned air in
the cooling mode. When set to 0 the system will use the factory default and
recommended rate of equipment cycling to maintain comfort. Increasing the
3 4 5
number will slow down the system, causing longer cycles. Reducing the number
will make the system react quicker, shortening the equipment cycle.
Air Handler Status (Menu > Settings > Installer > Air Handler)
Zone 3
Go to Menu > Settings > Installer (tap and hold) > Air Handler.
44% 44% 47%
Dining Room
Electric Heater Size – If electric strip heaters are installed in the air handler
Zone 3
you will need to select the appropriate size.
Electric Heat Airflow Select – Four choices available. Refer to air handler
44% 47% 44%
installation instructions for air flow settings.
Dining Room See pages 28-29 for the G Input and AUX Input details. These settings are the
same for both furnace and air handler.
EcoNet Smart Thermostat User Guide
®
31