Econet Smart Thermostat Installation Instructions; Safety Considerations; Thermostat Location - EcoNet UETST700SYS Guide D'utilisation

EcoNet Smart Thermostat Installation Instructions

The EcoNet System consists of several intelligent, communicating components. Commands, operating conditions,
and other data are passed continuously between components. All system components are controlled through the wall
mounted EcoNet Smart Thermostat, which replaces the conventional thermostat and provides the homeowner with a
single wall control for all features of the system.
Note: Read the entire instruction manual before starting the installation

Safety Considerations

Failure to read and follow all instructions carefully before installing or operating this control and system could cause
personal injury and/or property damage.
WARNING: Power off your Heating, Ventilation and Air Conditioning system by using the master switch or circuit
breaker box
Note: All wiring must comply with national, local and state codes

Thermostat Location

The EcoNet Smart Thermostat is the command center for the EcoNet System, as well as the control for the heating and
cooling equipment. It should be located where it is easily accessible and visible to the homeowner or end user. For
accurate zone temperature and humidity measurement, the following guidelines should be followed:
The EcoNet Smart Thermostat should be mounted:
• Approximately 5 feet (1.5 m) from the floor
• Close to or in a frequently used room, preferably on an inside wall
Decide if you want to use the adapter plate with your new EcoNet Smart Thermostat. The adapter plate is useful if you
want to hide marks or holes left by your previous thermostat.
Note: The adapter plate is sold separately. Adapter Plate - RETSTWPL700.
The EcoNet Smart Thermostat should NOT be mounted:
• Close to a window, on an outside wall, or next to a door leading to the outside.
• Exposed to direct light or heat from a lamp, sun, fireplace, or other temperature-radiating objects which could
cause a false reading
• Close to or in direct airflow from supply registers or returns
• In areas with poor air circulation, such as behind a door or in an alcove
• On a section of wall with pipes or ductwork
If you are installing with a remote temperature sensor, place your remote sensor at a height of approx. 5 feet
(1.5 m) on an interior wall, away from direct heat/cool sources (e.g. fireplace, air vents, etc.)
> Return to Table of Contents
Smart Thermostat User Guide 24
EcoNet
®