EcoNet UETST700SYS Guide D'utilisation page 12

Menu Options
80 80 68 80
Resume Schedule Away
71 75 75 75
Away
Home Home
62 85
72 65
OFF
Settings
Menu
80 80 68
Resume Schedule Away
75 75 71
Settings Schedule Status
Home Away
Water Heating
65 72
OFF
BACK
Settings
68 80 80
Resume Schedule Away
71 75 75
Time Humidity
Basic
Home Away
Away Vacation Fan
65 72
OFF
BACK
Basic Settings
68 80 80
Follow Schedule? Yes
Resume Schedule Away
71 75 75
Alarm Beep Enable? No
Screen Lock?
No
Temperature Display Fahrenheit
Away Home
Schedule Override Time 2 hours
Auto-Changeover Time 5 min.
72 65
OFF
BACK
> Return to Table of Contents
Tap the Menu icon in the bottom left corner of the home screen to easily
Zone 3
!
view and configure your personal and system settings.
44% 44% 44% 47%
Dining Room
Settings (Menu > Settings)
Zone 3
Adjust system-level settings and preferences, from customizing your away
temperatures to scheduling a vacation. Tap the Menu icon from the home screen
Service
44% 44% 47%
and then tap Settings.
Dining Room
Basic (Menu > Settings > Basic)
Zone 3
Adjust thermostat or basic equipment settings and preferences.
44% 47% 44%
Installer Dining Room
Follow Schedule – If a programmed schedule is desired, set to "Yes."
Zone 3
Alarm Beep Enable – Sounds an audible alarm tone shall a critical alarm
condition occur.
44% 44% 47%
Screen Lock– To lock the main screen from any changes, enable the lock. To
unlock, enter the Basic settings menu again and set Screen Lock to "No." This
Dining Room MORE
locking function prevents any changes except changes made from within the
Basic Settings.
Temperature Display – Change your indoor temperature and set points
between Fahrenheit and Celsius.
Schedule Override Time – While a schedule is running, if a set temperature
change occurs on the main screen, the change will be in effect for this amount of
time. The default is 2 hours. You can customize between a minimum override of
1 hour and a maximum of 8 hours. You can also choose to have the override in
effect until canceled, or until the next scheduled day part.
Auto Changeover Time – When the system is in Auto mode, this is the
amount of time demand must exist in the opposite mode (cooling or heating) in
order for the system to switch to that mode. The default is 5 minutes. The setting is
configurable between 5 and 60 minutes.
EcoNet Smart Thermostat User Guide
®
12