Hürner Hydr. 500 Manuel Utilisateur page 26

detected, the heating element is switched off. The control unit sup-
ports the following error messages:
Error 'E01' Temperature sensor not connected or ohm value too high
Error 'E02' Heating element temperature exceeds maximum (> 280°C)
Error 'E03' Short-circuit at the temperature sensor input
6 Service and Repair
As the product is used in applications sensitive to safety considerations,
it may be serviced and repaired only on our premises or by partners
who were specifically trained and authorized by us. Thus, constantly
high standards of operation quality and safety are maintained.
Non-compliance with this provision will dispense the manu-
facturer from any warranty and liability claims for the product
and any consequential damage.
Important
7 Service and Repair Contact
HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specifications of
the product without prior notice.
Info
8 Accessories/Parts for the Product
Facing Tool Blade for HÜRNER Manual Hydr. 500
Only genuine spare parts are acceptable. The use of non-
genuine parts voids any and all liability and warranty on the
part of the manufacturer.
Info
For consultation and ordering spare parts, refer to the seller or manu-
facturer of the product.
14
EN
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER Manual Hydr. 500 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version October 2020