Braun 93s Serie Mode D'emploi page 12

15 b Status light
15 c Cleaning program indicators*
16 Start button
17 Cleaning cartridge*
* not with all models (see display box)
C & C Installation
• Remove the protection foil from the C & C display.
• Press the lift button (13) at the rear side of the C & C to lift the housing.
• Hold the cleaning cartridge (17) down on a flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base of the station until it snaps in.
• Slowly close the housing by pushing it down until it locks.
• Using the power supply (10), connect the station power socket (12) to an electrical
outlet.
C & C Usage
Important: The shaver needs to be dry and free from any foam, gel or soap
residue!
• Insert the shaver in the C & C upside down, with the front showing and head lock (3)
released.
• The contacts (7) on the back of the shaver need to align with the contacts (14) in the
C & C. Push the shaver backwards in the correct position. A beep sound confirms that
the shaver sits properly in the C & C.
• Only C & C with cleaning program selection: The C & C analyses the hygiene status.
The status is shown by the cleaning program indicators (15c) in the C & C display (15).
Charging the shaver in the C & C
Charging will start automatically when the shaver has been inserted properly.
Cleaning the shaver in the C & C
When the cleaning indicator lights up on the shaver display, insert the shaver into the
C & C, as described above.
Cleaning programs (not with all models)
short / economical cleaning
normal level of cleaning
intensive cleaning
Each cleaning program consists of several cycles, where cleaning fluid is flushed
through the shaver head.
Automatic cleaning
Start the cleaning process by pressing the start button (16). If status light (15b) does
not shine (C & C switches to stand-by after ca. 10 minutes), press start button twice.
Otherwise, cleaning will not start.
12