Publicité
Les langues disponibles
Les langues disponibles
S
YMPTOM
ERROR 3
Foreign objects are preventing
(Loading Error)
the disc from loading
Loading area in mechanism and
loading motor (or driving circuit)
is defective
ERROR 4
Foreign objects are preventing
disc from ejecting
(Eject Error)
Eject area in mechanism and
ejecting motor (or driving circuit)
is defective
Transverse motor or switch is
ERROR 6
defective or Traverse area of disc
(Transverse Error)
is damaged
Excessive dirt or dust on disc
ERROR 7
(Servo Error)
Disc is warped cracked or
severely damaged
Excessive scratches on disk
Disc is cracked, warped or
ERROR 9
(TOC Error)
severely damaged
Laser pickup is defective
Servo unit in CDP mechanism is
not operating properly
No RF suppression of blower
Radiated Noises
motors
No RF suppression of switches
CD skips
Source unit mounted at an
incorrect angle
excessively
Source unit not secured properly
(Standard Mount)
Source unit not secured properly
(ISO Mount)
All manuals and user guides at all-guides.com
D
IAGNOSIS
R
EMEDY
Check CDP mechanism load area by
removing faceplate and repair as necessary
Repair the mechanism and loading motor
(or driving circuit)
Check CDP mechanism eject area by
removing faceplate and repair as necessary
Repair the mechanism and loading motor (or
driving circuit)
Check CD mechanism motor and switch.
Put in a different disc!
Clean disc to remove dirt or dust as necessary
Put in a different disc!
Put in a different disc!
Put in a different disc!
Have service center repair laser pickup
Check the servo circuit area and repair as
necessary
Connect filter cap (Radio Shack #272-1085)
in-line on B+ near blower motor.
Connect a .1µf – .01µf non-polarized
capacitor across switch contacts
Check mounting angle of source unit (mount
within ±20˚ from horizontal) and repair as
necessary
Check tightness of installation sleeve and back
strap; repair or replace as necessary
Check tightness of mounting screws and repair
or replace as necessary
T
ROUBLESHOOTING
21
Publicité
