Audiovox PRESTIGE PLATINUM APS 500 Manuel De L'utilisateur page 7

PROGRAMMING THE CUSTOM CODE MANUAL OVERRIDE
Your Security System can be disarmed without the use of the keychain transmitter. This is
necessary, since you will need the ability to disarm the system if you lose your transmitter,
or if the transmitter battery fails.
If your system has been selected for Custom Code manual override as indicated on the
last page of this manual, in order to provide the highest level of security, this system will
allow you to program your personal manual override code.This code is a ( 2 ) digit code.
The first digit must be a digit from 1 through 9, and the second digit must be either 1, 2, or
3.
To program your access code, the security system must be in the disarmed state. Once
disarmed, program your code as follows;
1. Turn the ignition key on, then off, then on.
2. Within 3 seconds of step 1, flip the Valet switch on, then off. The siren will
sound one short chirp, followed by one long chirp. This indicates that the
system is in the manual override programming mode.
3. The red dash L.E.D. will begin to count by flashing. Allow the L.E.D. to flash
until it gets to the first digit of your selected code.
4. As soon as the L.E.D. turns on for the corresponding number of your first
digit, quickly turn the ignition key;
1. off then on for second digit 1
2. off then on twice for second digit 2
3. off then on three times for second digit 3.
5. The siren will sound one short chirp, followed by one long chirp, indicating
that the code has been memorized.
6. After a 2 second pause, the L.E.D. will flash confirmation of the stored code,
beginning with the first digit, then a pause, then the second digit.
EXAMPLE : To program the manual override code 52, you would;
1. Turn the ignition key on, then off, then on.
2. Within 3 seconds of step 1, flip the Valet switch on, then off. The siren will
sound one short chirp, followed by one long chirp. This indicates that the
system is in the manual override programming mode.
3. Allow the L.E.D. to flash 5 times, and during or immediately after the fifth
flash, quickly turn the ignition key to off, then on, then off, then on.
4. The siren will sound one short chirp, followed by one long chirp, indicating
that the code has been memorized.
5. After a 2 second pause, the L.E.D. will flash 5 times, then pause, then flash
2 times. This confirms that the code 52 has been stored into memory.
Page 7
128-4635B
7 of 30