URBANGLIDE PO3293 Notice Originale page 26

To enter the settings for your product, press the "+" and "-" buttons on your screen for 5 seconds.
Attention! If you change all the basic settings, you change the performance and condition of your product. We
recommend that you only change the settings below:
Menu
P01
P02
P04
0 = No sleep mode
P09
ERROR
E06 Check that your battery is fully charged. If so, check that the battery compartment (Tray) is not damaged.
E07
Check the condition of the cables in your product. Then check the condition of the motor(s).
E08
Check that the throttle trigger is in good condition. Check the condition of your product's cables.
E09
E10
Signal lost, check the condition of the cables in your product. This problem may be caused by the
E11
Signal lost, check the condition of the cables in your product. This problem may be caused by the screen.
E30
Go to the settings of your product by pressing and holding down the "+" and "-" buttons. Go to setting
System settings
Brightness adjustment
Adjusting the unit of measurement of the distance
0 = KM
Screen saver time
1 to 60 = The number of minutes of standby time
0 = Immediate start
Error code
Then check the condition of your product's cables.
Check the condition of the cables in your product. Changed the motherboard.
motherboard or the display.
Transmission cable
Communication error
Setting
1=MILES
Start-up mode
1 = Impulse to start
PROBLEM
Battery
Motor
Accelerator
Motherboard
Reception cable
P20 and enter 0.
11